Polyurea Waterproofing in Egypt
ISC Group applies polyurea waterproofing and protective coatings for specified roof, tank and industrial applications in Egypt. We review the substrate, exposure and required finish before confirming the product, primer and coating build-up.
Spray-applied polyurea for a continuous protective layer
Polyurea can form a continuous coating across suitable surfaces, including areas with complex geometry. Fast curing does not remove the need for preparation, joint detailing and controlled application. The performance required for a roof can differ from that required inside a tank or an industrial containment area.
Roof and industrial waterproofing
We review drainage, movement, penetrations and exposure before applying the system. Any requirement for UV protection or a separate finish is checked against the selected product data. Compare the proposed coating with bituminous membranes and other waterproofing systems during the technical review.
Tank and containment coatings
Selection depends on the stored liquid, operating temperature and cleaning conditions. A coating intended for drinking-water contact needs the relevant approval for that specific product and use. These requirements should be confirmed before procurement.
Preparation and application controls
- Inspect surface strength, moisture and existing coatings.
- Prepare the substrate and repair defects before priming.
- Detail joints, corners and penetrations for the specified system.
- Control application equipment, material conditions and the required thickness.
- Inspect continuity and complete the specified checks before handover.
Where concrete damage or an active leak is present, coordinate concrete repair or injection treatment before covering the surface.
Questions about polyurea coatings
Can polyurea be applied over an existing coating?
Only after assessing adhesion and compatibility. The old coating may need removal, and trials or checks may be required before the application method is approved.
When can the area return to service?
The product, thickness, site conditions and intended use determine the handover time. The application plan must also allow for preparation, inspection and any subsequent protective finish.
How do I request a proposal?
Send drawings, area, condition photographs and details of water or chemical exposure. Include access restrictions and the available work period so the team can define the scope.
Discuss your project with our technical team.
Share your project location, drawings, quantities and site photographs so we can review the requirements.